15
Operation
DISHWASHER SETUP
Before using your dishwasher for the rst time:
A. Set the water softener
B. Load the salt into the water softener
C. Fill the rinse aid dispenser
D. Fill in the detergent
A. Water Soener
The water softener is designed to remove minerals and salts from the water, which would have a
detrimental or adverse effect on the operation of the appliance. The higher the content of these minerals
and salts, the harder the water is. The softener should be adjusted according to the hardness of the water
in your area. Your local water authority can advise you on the hardness of the water in your area.
Seing:
The amount of salt dispensed can be set from H0 to H7, depending on the hardness of your water. Salt is
not required at the set value H0.
1. Find out the hardness value of your tap water. Your water utility company will help you with this.
2. Set value can be found in below water hardness table.
3. Close the door.
4. Press Power button.
5. Hold down Delay button, then press Program button for 5 seconds. The buzzer rings once, a “H”
ashes on the display. (Factory setting is H0.)
6. Press Delay button. Each time the button is pressed, the set value increases by one level; when the
value of H7 has been reached, the display jumps back to H0 (off).
7. Press Program button. The chosen setting is stored.
Water hardness
Mmol/l
Set value on
the machine
Clark Range
0-8
Soft 0-1.1
H0
9-10
Soft 1.2-1.4
H1
11-12
Medium 1.5-1.8
H2
13-15
Medium 1.9-2.1
H3
16-20
Medium 2.2-2.9
H4
21-26
Hard 3.0-3.7
H5
27-38
Hard 3.8-5.4
H6
39-62
Hard 5.5-8.9
H7
To Next Page
Loading...
