Home HME030286N - Troubleshooting; Error Codes Explained; Basic Operational Troubleshooting

30
Troubleshooting
ERROR CODES
When some malfunctions happen, the appliance will display error codes to warn you.
CODE MEANING POSSIBLE CAUSES
E1 Door open The door is opened when the dishwasher is operating.
E2 Water inlet Water inlet malfunction
E3 Water drainage Water drainage malfunction
E4 Temperature sensor Temperature sensor malfunction
E5 Overow/leakage Overow occurs/Water leakage occurs
E6 Water leakage Water leakage occurs
E7 Heating element Abnormal heating
WARNING
If overow occurs, turn off the main water supply before calling a service. If there is water in the base pan
because of an overll or small leak, the water should be drained before restarting the dishwasher.
BEFORE CALLING FOR SERVICE
PROBLEM POSSIBLE CAUSES SOLUTIONS
Dishwasher
doesn't run
Fuse blown, or the circuit
breaker acted
Replace fuse or reset circuit breaker. Remove any other
appliances sharing the same circuit with the dishwasher.
Power supply is not
turned on
Make sure the dishwasher is turned on and the door is
closed securely. Make sure the power cord is properly
plugged into the wall socket.
Water pressure is low Check that the water supply is connected properly and
the water is turned on.
Drain pump
doesn't stop
Overow The system is designed to detect an overow to protect
itself. When overow happens, the system shuts off the
circulation pump and turns on the drain pump.
Noise
Some audible sounds are
normal
Sound comes from detergent cup opening.
Utensils are not secure in
the baskets or something
small has dropped into
the basket.
Ensure everything is secured in the dishwasher.
Motor hums Dishwasher has not been used regularly. If you do not use
it often, remember to set it to ll and pump out every
week, which will help keep the seal moist.