Home HME030286N - Control Panel Functions

26
Operation
CONTROL PANEL
18 2
7
9
6
4 3
5
MIN
DELAY START/PAUSE PROGRAM
ON/OFF
Add Rinse Aid
Add Salt
Water
Supply
Heavy
Wash
Dry
Normal
Delicate
Light
Express
Rinse
NOTE:
Buttons are sensitive and should be touched gently. Avoid any grease or food particles resting on the
buttons as this could activate the dishwasher. Wiping and cleaning can also activate the dishwasher.
Forbest results, use bare and clean hands when touching the buttons.
WARNING:
To avoid risk of injury, always use caution when opening the door during or following a wash cycle, as hot water
or steam may escape. Do not fully open the door until water noises have stopped and steam has subsided.
1. On/Off: Turn on/off the dishwasher.
2. Program: Select a washing program.
3. Program indicators: When you select a washing program, the corresponding indicator will light up.
4. Drying indicator: Lights up when the dishwasher is drying.
5. Washing/Inlet water abnormal status indicator: When the dishwasher is working, the “Wash”
indicator is on. When water supply problem happens, the “Water Supply” indicator lights up.
6. Salt/Rinse aid rell indicator: Lights up when the softener or dispenser needs to be relled.
7. Start/Pause: Start or pause the expected washing cycle.
8. Delay: Allow to delay the start time up to 24hours.
9. Digital display: To display the remain running time, malfunction codes and delay time.
START A WASH CYCLE
1. Draw out the lower and upper basket, load the dishes and push them back. It is recommended
to load the lower basket rst, then the upper one (See “Load the dishwasher” section). Fill in the
detergent (See “Detergent” section).
2. Insert the plug into the socket.
3. Make sure that the water supply is turned on to full pressure. Close the dishwasher door and press
Power button. Press Program button to select the wash cycle. (See “Wash Cycle Table” section).
4. Press Start/Pause button and close the dishwasher door within 4 seconds, the dishwasher will be
activated, otherwise the dishwasher will not start working. A click could be heard when the door is
closed perfectly.
5. When the washing is over, press Power button to turn off the dishwasher.