Home HME030286N - Cleaning the Filter System; Cleaning the Spray Arms

28
Cleaning and Maintenance
CLEAN THE FILTER SYSTEM
For best performance and results, the lter system must be
cleaned. Remove the large food particles trapped in the lter
after each wash cycle by rinsing the semicircular lter and cup
under running water.
• Inspect the lters for obstructions every time the dishwasher
has been used.
• By unscrewing the coarse lter, you can remove the lter
system. Remove any food remnants and clean the lters under
running water.
• Use a cleaning brush to clean the coarse lter and the micro lter.
• After cleaning, assemble the lter parts as shown in gures
above and reinsert the entire assembly in the dishwasher,
positioning in its seat and pressing downward.
WARNING:
• Never run the dishwasher without the lters in place.
• Improper replacement of the lter may reduce the performance level of the appliance and damage
dishes and utensils.
• When cleaning the lters, do not knock on them. Otherwise, the lters could be contorted and the
performance of dishwasher could be reduced.
To disassemble the lters, follow below steps:
Step 1 Rotate the coarse lter anticlockwise, then lift it up.
Step 2 Lift the at lter up.
The lter system consists of a coarse lter, a at lter (Main lter) and a micro lter (ne lter).
1. Flat lter
Food and debris will be trapped by a special jet on the lower spray arm.
2. Coarse lter
Big debris, such as bone and glass that could clog the drain will be trapped in the coarse lter.
To remove an item caught in this lter, gently squeeze the taps on the top of this lter and lift it out.
3. Micro lter
This lter holds soil and food residue in the sump area and prevents it from being redeposit on the
dishes during a cycle.
CLEAN THE SPRAY ARMS
Clean the spray arms regularly since hard water chemicals will clog
the spray arm jets and bearings.
• To remove the spray arms, screw off the nut clockwise, take out
the washer on top of the spray arm and then remove the arm.
• Wash the arms in soapy and warm water. Use a soft brush to
clean the jets.
• Replace them after rinsing thoroughly.
2
3
1