16 17
Operating Instructions
Aaching the Top Rail to the Air Conditioner
(CONT.)
5. Insert top and bottom legs of window ller
panel frame into channel in the top angle and
bottom rail. Do both sides. Install side retainer
to cabinet as shown. (FIG.8b-9).
5/16" Long
Hex-head Screw
FIG.8b
FIG.9
Placing the Cabinet Inside the Window
1. Open the window and place the cabinet in the
middle of the window sill.
2. Make sure the bottom rail is seated over the
window sill as shown below. Bring the window
down temporarily behind the top angle rail to
hold the cabinet in place. (It is suggested to
keep a downward angle so accumulated rain
water can drain out from the backside of the
unit.)
3. Fasten cabinet to window sill using two 5/8”
Round -Head screws. Pre-drill holes if needed.
Add the bottom rail seal over the screws.
5/8" Long
Hex-head Screw
Gasket
Install Support Brackets
1. Hold each support bracket ush against
the outside of the window sill. Tighten each
bracket to the bottom of the cabinet as shown
below. Mark the brackets at top lever of the
window sill and then remove.
Mark
5/8" Long Flat Head Bolt
Long Flat head
Bolt and Locknut
Operating Instructions
Install Support Brackets (CONT.)
2. Assemble the sill angle brackets to the
support brackets at the marked position as
shown above. Hand tighten, but not all the way
for any changes that may need to be made
later during installation.
3. Install the support brackets (with sill angle
brackets attached) to the bottom of the
cabinet as shown below.
4. Tighten all 6 bolts securely.
Long
Flat head
Bolt and
Locknut
Extend the Accordion Panels
1. Carefully raise the window to expose the
accordion panel and panel frame. Loosen the
locking screws so the accordion panels slide
easily.
5/8" Long
Hex-head Screw
1/2" Long
Hex-head Screw
2. Extend each panel to completely ll the width
of the window. Tighten the locking screws
when the panels are fully extended.
Install the Window Lock and Sash Seal
1. Trim the sash seal to t the width of the
window. Insert the sash seal into space
between the upper and lower sashes.
2. Attach the right angle sash lock as shown
below.
5/8" Long
Hex-head Screw
Sash Lock
Installing the Chassis into the Cabinet
1. Team lift (two people) the air conditioner
chassis and carefully slide it into the cabinet.
Let the front of the air conditioner hang out
approximately 6”.
2. CAUTION: DO NOT PUSH ON THE CONTROLS
OR FINNED COILS.
3. Be sure the chassis is rmly seated in the back
of the cabinet.
4. Insert all screws removed during window
installation and reattach the front face plate,
front panel, and the air lter. Use the REMOVE
CHASSIS instructions and gures 5-11 for
reference.
To Next Page
Loading...
