14
Operation (continued)
Operating Instructions
sure the batteries are tted in the laser guide before carrying out precision cutting. To t the
batteries, remove the battery storage cover(c), insert 2 x 1.5v AAA batteries, then replace cover.
NOTE: Ensure correct battery polarity.
To use the laser guide, simply slide the laser on/o switch(b) at the “I” position, the laser guide
then projects a visible red line on the workpiece surface, make your cut along the red line.
Switch o the laser after cutting.
NOTE: The sawdust may “block” the laser beam, clean the laser generator periodically.
WARNING: Never stare directly into the laser beam and never point the beam
at anybody.
DANGER: Laser radiation. Avoid direct eye contact with light source.
To Next Page
Loading...