homelabs Nugget - User Manual

Questions and Answers

R
rcamposJul 29, 2025
What to do if there is mold in my homelabs Nugget?
- B
  Brandon FoxJul 29, 2025
  If you find mold or residue buildup, turn off the unit and clean all interior surfaces with room temperature water and mild detergent using a soft cloth. Rinse with water, then run 3 cycles of ice making with new water each time, discarding the ice. For best results, use a professional ice machine descaler and sanitizing solution, following the manufacturer’s instructions. Regularly cleaning the water, scoop, ice machine, and surrounding area can help prevent mold formation.
S
sabrina38Aug 5, 2025
What to do if my homelabs Nugget is leaking water?
- K
  Katherine TaylorAug 5, 2025
  If your ice maker is leaking, first check if the Drain Cap is securely in place. If the leakage continues, further assistance is needed.
W
Willie BradyAug 10, 2025
What to do if “LIGHT” and “ICE” icons are flashing on my homelabs Nugget?
- J
  Joseph RiversAug 10, 2025
  If the “LIGHT” and “ICE” icons are flashing, it could be due to the ambient or water temperature being too high. Ensure the ice maker is running below 90°F and use colder water. Alternatively, it may indicate a refrigerant liquid leakage. In this case, touch the “ICE” button twice to restart the ice making program and wait for 50 minutes. If the problem continues, further assistance is needed.
F
frank01Aug 16, 2025
Why is my homelabs Ice Maker producing ice slowly?
- S
  Spencer FitzgeraldAug 16, 2025
  Slow ice production can occur due to a few reasons. First, ensure the Hot Air Outlet has more than 5.9 inches of clearance for proper ventilation. Also, the water temperature in the inner tank should be between 45–90°F. If these steps don't resolve the issue, it could indicate a malfunctioning refrigeration system, requiring professional attention.
D
David SchmittAug 23, 2025
How to fix no ice cubes inside homelabs Nugget?
- B
  Brian AustinAug 23, 2025
  If there are no ice cubes inside, there may be an obstruction. Remove any obstructions or clean the interior surface of the drawer. After doing so, unplug the unit and restart it.