Homelite 26CS UT22600

Questions and Answers

B
Bryan GarciaAug 18, 2025
What to do if grass wraps around drive shaft housing and string head of Homelite 26CS UT22600?
- K
  kimberly68Aug 18, 2025
  If grass is wrapping around the drive shaft housing and string head of your Homelite Trimmers, it is likely caused by: * Cutting tall grass at ground level: Cut tall grass from the top down to prevent wrapping. * Operating trimmer at part throttle: Operate the trimmer at full throttle.
C
Courtney EvansAug 21, 2025
Why Homelite 26CS UT22600 Trimmers string will not advance?
- W
  Whitney FreyAug 21, 2025
  If the string on your Homelite Trimmers isn't advancing, consider these potential causes and solutions: * String welded to itself: Lubricate with silicone spray. * Not enough string on spool: Install more string. * String worn too short: Pull strings while alternately pressing down on and releasing spool retainer. * String tangled on spool: Remove string from spool and rewind. * Engine speed too slow: Advance string at full throttle.
J
John DavisAug 25, 2025
What to do if Homelite 26CS UT22600 Trimmers spool retainer hard to turn?
- C
  Carolyn WilliamsAug 26, 2025
  If the spool retainer on your Homelite Trimmers is hard to turn, it's likely because the screw threads are dirty or damaged. Clean the threads and lubricate them with grease. If this doesn't improve the situation, replace the spool retainer.
J
Julie PerezAug 27, 2025
What to do if Homelite 26CS UT22600 Trimmers engine does not reach full speed and emits excessive smoke?
- P
  pedro44Aug 27, 2025
  If your Homelite Trimmers engine isn't reaching full speed and is emitting excessive smoke, the causes and solutions are: * Check the lubricant fuel mixture. Use fresh fuel and the correct 2-cycle lubricant mix. * The air filter may be dirty. Clean the air filter. * The carburetor may be out of adjustment, in this case you should contact an authorized servicing dealer.
J
joshuahallAug 31, 2025
Why Homelite 26CS UT22600 Trimmers lubricant drips from muffler?
- J
  John HudsonAug 31, 2025
  If lubricant is dripping from the muffler of your Homelite Trimmers, it could be due to: * Operating the trimmer at part throttle: Operate the trimmer at full throttle. * Incorrect lubricant/fuel mixture: Use fresh fuel and the correct 2-cycle lubricant mix. * Dirty air filter screen: Clean the air filter.
J
James KennedySep 3, 2025
Why Homelite 26CS UT22600 engine starts but will not accelerate?
- T
  taramarshSep 3, 2025
  If your Homelite Trimmers engine starts but won't accelerate, it might need to warm up for about three minutes. If it still doesn't accelerate after warming up, contact a servicing dealer.
L
Lee WatsonSep 6, 2025
Why Homelite 26CS UT22600 Trimmers engine starts but will only run at high speed at half choke?
- T
  timothysmithSep 6, 2025
  If your Homelite Trimmers engine starts but only runs at high speed at half choke, the carburetor likely requires adjustment. Contact an authorized servicing dealer to resolve this issue.
H
Heather FitzgeraldSep 10, 2025
Why Homelite 26CS UT22600 Trimmers engine starts, runs, and accelerates but will not idle?
- U
  ucabreraSep 12, 2025
  If your Homelite Trimmers engine starts, runs, and accelerates but won't idle, the idle speed screw on the carburetor likely needs adjustment. Turn the idle speed screw clockwise to increase the idle speed.
M
Monica Cochran MDNov 13, 2025
Why Homelite Trimmers engine will not start?
- S
  stephen79Nov 13, 2025
  To troubleshoot a Homelite Trimmers engine that won't start: * Check for spark by removing the spark plug, re-attaching the cap, and laying it on the metal cylinder. Pull the starter rope to check for a spark at the tip. If there's no spark, try again with a new spark plug. * Push the primer bulb until it fills with fuel. If it doesn't fill, the fuel delivery system might be blocked, and you should contact a servicing dealer. If the bulb fills, the engine may be flooded. * Remove the spark plug, turn the trimmer so the spark plug hole faces the ground, rotate the choke dial to the “RUN” position, and pull the starter cord 10 to 15 times to clear excess fuel. Clean and reinstall the spark plug. * Pull the starter three times with the choke dial at “RUN”. If it doesn't start, rotate...