Homelite UT43103 User Manual

Page 24 — English
OPERATION
OVERBUCKING
Fig. 21
FINISHING
CUT
FIRST CUT
1/3 DIAMETER
SECOND
CUT
LOAD
Fig. 23
UNDERBUCKING
Fig. 22
OVERBUCKING
See Figure 21.
Begin on the top side of the log with the bottom
of the saw against the log; exert light pressure
downward. Note that the saw will tend to pull
away from you.
UNDERBUCKING
See Figure 22.
Begin on the under side of the log with the top
of the saw against the log; exert light pressure
upward. During underbucking, the saw will tend
to push back at you. Be prepared for this reaction
and hold the saw firmly to maintain control.
WARNING:
Never climb into a tree to limb or prune. Do
not stand on ladders, platforms, a log, or in
any position which can cause you to lose your
balance or control of the saw and cause death
or serious personal injury.
LIMBING
See Figure 23.
Limbing is removing branches from a fallen tree.
 Work slowly, keeping both hands on the chain
saw with a firm grip. Always make sure your
footing is secure and your weight is distributed
evenly on both feet.
 Leave the larger support limbs under the tree
to keep the tree off the ground while cutting.
 Limbs should be cut one at a time. Remove the
cut limbs from the work area often to help keep
the work area clean and safe.
 Branches under tension should be cut from the
bottom up to avoid binding the chain saw.
 Keep the tree between you and the chain saw
while limbing. Cut from the side of the tree
opposite the branch you are cutting.

Homelite UT43103 Specifications

General

Brand	Homelite
Model	UT43103
Category	Chainsaw
Language	English