Need help?Do you have a question about the Homelite XL-2 and is the answer not in the manual?
General| Engine Type | 2-cycle |
|---|---|
| Power Output | 1.8 HP |
| Chain Pitch | 3/8 inch |
| Chain Gauge | 0.050 inch |
| Weight | 9.2 lbs |
| Bar Length | 16 inches |
| Oil Capacity | 6.8 oz |
Instructions for repairing the starter assembly, including rope and pulley replacement.
Steps to detach the engine from the chainsaw housing, including screw removal.
Procedures for taking apart the engine components like carburetor and crankshaft.
Procedure for removing the throttle assembly cover, including trigger and screw removal.
Instructions for assembling the crankcase and cylinder, including piston and bearing installation.
Steps for reassembling the engine into the housing, aligning throttle rod and lever.
Diagnosing and fixing common ignition system problems like no spark or fouled plugs.
Cleaning cylinder fins, muffler, spark arrestor, and checking cylinder ports for carbon buildup.
Exploded view and troubleshooting for the diaphragm pump type oil system.
Diagnosing issues with no or low oil output in the diaphragm pump oil system.
Explanation and diagram of the pressure feed oiling system used in XL model chain saws.
Diagnosing issues with no, low, or high oil output in the pressure feed oiling system.
Troubleshooting steps for engines that fail to start or have difficulty starting.
Diagnosing and fixing fuel flow issues to the carburetor, including filter and diaphragm problems.
Troubleshooting for engines that start but stall during operation, possibly due to vaporlock or air leaks.
Diagnosing and fixing issues causing the engine to run rich or flood, often related to air filters or carburetors.
Troubleshooting for engines overheating, caused by clogged fins, stale fuel, or improper adjustment.
Diagnosing and resolving engine misfires that occur when the saw is under load.
Troubleshooting steps for an engine that lacks power, possibly due to air leaks or carburetor issues.
Torque specifications for common fasteners used in the assembly of the chain saw.
Torque specifications specific to the XL model with plastic housing, listing various screw types and applications.
Torque specifications for XL and Super 2 models, covering components like oil pump cover and handle bar.
Key engine specifications including bore, stroke, compression, speed, and gap settings.
To Next Page