38
Mounting
5 Mounting
Before starting to set-up the device, you have to connect
the single components of the weather sensor supplied.
To do this, please proceed as follows:
Step 1:
• Remove the not yet completely assembled
weather sensor and the anemometer (A) from
the packaging.
• Put the anemometer to tube 2 (F) above the main
sensor (B).
• Please make sure that the notch of the rotary axis
matches with the screw hole (see fig. 4).
• Fasten the anemometer with the screw (see fig.
5).
Step 2:
You can install the weather sensor using the stainless
steel mast (F) or using the hose clamp (I) and the tube
connector (H) for mounting the device to other tubes or
mounting brackets.
Alternative A: Mounting with stainless steel mast
• Remove the tubes of the stainless steel mast (F)
from the packaging.
• Join the tubes together.
To Next Page
Loading...
Need help?
General
