41
Teaching-in
6 Teaching-in
Please read this entire section before
starting the teach-in procedure.
First set up your Homematic IP Access Point via
the Homematic IP app to enable operation of
other Homematic IP devices within your system.
For further information, please refer to the oper-
ating manual of the Access Point.
You can connect the device either to the Access
Point or to the Homematic Central Control Unit
CCU2. For detailed information, please refer to
the Homematic IP User Guide, available for
download in the download area of
www.eQ-3.com.
To teach-in the weather sensor to the Access Point,
please proceed as follows:
• Open the Homematic IP app on your smart-
phone.
• Select the menu item “Teach-in device”.
• Loosen the cover of the main sensor (B) by turn-
ing the cylinder clockwise and pulling it down-
wards.
• Remove the insulation strip from the battery
compartment (E) to activate the teach-in mode.
To Next Page
Loading...
Need help?
General
