To Next PageTo Next PageWhat to do if HomeMatic Thermostat command not confirmed?
If a command is not confirmed on your HomeMatic Thermostat, it could be due to radio interference, the receiver being unreachable or defective, or the receiver's inability to execute the command. In any of these cases, wait until transmission has been confirmed.
What to do if HomeMatic Thermostat duty cycle exceeded?
If the duty cycle is exceeded or transmission failed on your HomeMatic Thermostat, please try again.
What to do if HomeMatic HMIP-WTH Thermostat battery voltage is low?
If the battery voltage is low on your HomeMatic Thermostat, replace the batteries of the device.
How to fix weak battery in HomeMatic Thermostat?
To fix a weak battery in your HomeMatic Thermostat, replace the empty batteries with two new batteries.
General| Brand | HomeMatic |
|---|---|
| Model | HMIP-WTH |
| Category | Thermostat |
| Language | English |
Explains symbols like Attention and Note used throughout the manual.
Details the physical components of the wall thermostat as shown in Figure 1.
Explains the symbols and indicators shown on the device's display (Figure 2).
Instructions on how to integrate the device into the Homematic IP system via the app.
General instructions for physically attaching the thermostat to a wall.
Detailed steps for mounting the device using double-sided adhesive strips.
Step-by-step guide for securing the thermostat to the wall using screws and plugs.
Guidance on integrating the thermostat with other switch systems or multi-gang frames.
Discusses low battery indicators, their meaning, and the solution.
Explains issues when a command is not confirmed and potential causes like radio interference.
Explains the legal limit on transmission time and its implications for device operation.
Lists various error codes and LED flashing patterns with their meanings and solutions.
Advises on proper disposal of electronic equipment according to directives.
Explains the CE mark and provides information on technical support.
