26
Hazard information
We accept no liability for damage to property or personal injury
caused by improper use or the failure to observe the hazard warn-
ings. In such cases, all warranty claims are void. We accept no liabil-
ity for any consequential damage.
When connecting to the device terminals, observe the cables and
cable cross-sections permitted for this purpose.
Disconnect and cover live parts in the vicinity before installing and
connecting the device.
The device is part of the building installation. Observe the relevant
national standards and directives during planning and set-up. The
device is intended for operation within the Homematic IP Wired bus
only. The Homematic IP Wired bus is a SELV power circuit. Common
cable routing of power supply and the Homematic IP Wired bus in
installation or junction boxes is not permitted. The required isolation
for power supply of the building installation to the Homematic IP
Wired bus must be observed at all times. Non-compliance with the
installation instructions can cause fire or introduce other hazards.
The device may only be used for fixed installations. The device must
be securely attached within a fixed installation.
Observe the installation instructions for installation in distribution
systems (DINVDE0100-410).
Klassifiziert nach DIN EN 60825-1:2015-07
LASER
1
Do not point the laser beam at people. Do not look directly into
the beam or its reflection. Manipulating (modifying) the laser de-
vice is not permitted. These operating instructions must be kept
in a safe place and accompany the laser device if it is given to a
third party.
If you use the device/system in a security application, it has to be
operated in connection with a UPS (uninterruptible power supply) in
order to bridge possible power failure.
To Next Page
Loading...