Honda CBR 954RR - Service Manual

I I GENERAL INFORMATION
SERVICE RULES 1 - 1 LUBRICATION & SEAL POINTS 1 - 19
MODEL
I DENT1 FlCATl ON 1 - 1 CABLE & HARNESS ROUTING 1 - 23
SPECIFICATIONS 1
- 3 EMISSION CONTROL SYSTEMS 1 - 37
TORQUE VALUES
TOOLS
1
- 12 EMISSION CONTROL INFORMATION
LABELS 1
- 40
1
- 17
SERVICE RULES
1. Use genuine Honda or Honda - recommended parts and lubricants or their equivalents. Parts that do not meet Honda's
2. Use the special tools designed for this product to avoid damage and incorrect assembly.
3. Use only metric tools when servicing the motorcycle. Metric bolts, nuts and screws are not interchangeable with English
4. Install new gaskets, O - rings, cotter pins, and lock plates when reassembling.
5. When tightening bolts or nuts, begin with the larger diameter or inner bolt first. Then tighten to the specified torque
diagonally in incremental steps unless a particular sequence is specified.
6. Clean parts in cleaning solvent upon disassembly. Lubricate any sliding surfaces before reassembly.
7. After reassembly, check all parts for proper installation and operation.
8. Route all electrical wires as shown on pages 1 - 23 through 1 - 36, Cable and Harness Routing.
design specifications may cause damage to the motorcycle.
fasteners.
MODEL IDENTIFICATION
1-1

Summary

General Information

Service Rules

Rules for using genuine Honda parts, metric tools, and proper assembly procedures.

Model Identification

Guidance on locating and identifying the frame, engine, and color labels on the motorcycle.

Specifications

Detailed technical specifications for dimensions, frame, engine, drive train, and electrical systems.

Torque Values

Critical torque values for various fasteners and assembly points across the motorcycle's systems.

Tools

List of specialized tools required for servicing the motorcycle, including part numbers and references.

Lubrication & Seal Points

Diagrams and instructions for applying sealant and lubricant to critical mating surfaces and components.

Cable & Harness Routing

Diagrams illustrating the correct routing of wires, cables, and hoses throughout the motorcycle's chassis and engine.

Emission Control Systems

Explanation of systems designed to reduce exhaust emissions, including crankcase and secondary air supply.

Evaporative Emission Control System (California Type Only)

Details the evaporative emission control system for California models, including EVAP canister and purge control.

Emission Control Information Labels

Information on the location and content of emission control labels for tune-up specifications.

Honda CBR 954RR Specifications

General

Displacement	954 cc
Bore x Stroke	75.0 mm x 54.0 mm
Compression Ratio	11.5:1
Ignition	Computer-controlled digital transistorized with electronic advance
Transmission	6-speed
Front Brakes	Dual 330 mm discs with four-piston calipers
Rear Brakes	Single 220 mm disc with single-piston caliper
Seat Height	32.3 inches
Fuel Capacity	4.8 gallons
Engine Type	Liquid-cooled inline four-cylinder
Fuel System	PGM-FI fuel injection
Final Drive	O-ring-sealed chain
Front Suspension	43mm inverted HMAS cartridge fork with preload, compression and rebound damping adjustability
Rear Suspension	HMAS Pro-Link single shock with preload, compression and rebound damping adjustability
Front Tire	120/70ZR-17
Rear Tire	190/50ZR-17
Wheelbase	55.1 inches
Dry Weight	370 pounds