Honda FF500 - Rear Wheel Tread Adjustment

25
Rear wheel tread adjustment
WIDE TREAD
NARROW TREAD
WHEEL PIN
RETA INING PIN
RETA INING PIN
REAR WHEEL
WIDE TREAD:
500 mm (19.7 in)
NARROW TREAD:
300 mm (11.8 in)
Set the tiller on a firm level ground and hold it securely by placing a
suitable block under the transmission case and raising the rear
wheels off the ground.
Remove the retaining pin and wheel pin, and remove the rear
wheels.
Reverse and slide the rear wheels onto the wheel shaft.
Insert the wheel pin by aligning the pin holes and install the
retaining pin. Be sure to install the right and left rear wheels in the
symmetrical positions.
Rear wheel position can be changed to adjust the rear wheel tread in
accordance with the tilling width.
1.
2.
3.
4.