9. TROUBLESHOOTING
When the engine will not start:
1. Is there enough fuel?
2. Is the fuel valve on?
3. Is gasoline reaching the carburetor?
To check, loosen the drain screw with the fuel valve on. Fuel should
flow freely.
m If anv
. fuel is spilled, make sure the area is dry before testing the
spark plug or starting the engine. Spilled fuel or fuel vapor may ignite.
..f
4. Is the engine switch on?
5. Is there a spark at the spark plug?
/
a. Remove the spark plug cap. Clean any dirt from around the spark plug
’
base, then remove the spark plug.
b. Install the spark plug in the plug cap.
c. Turn the engine switch-on.
d. Grounding the side electrode to any engine ground, crank the engine
to see if sparks jump across the gap.
e. If there are no sparks, replace the plug.
If OK, try to start the engine according to the instructions.
i
6. If the engine still does not start, take the snowblower to an authorized
Honda snowblower dealer.
When the auger or blower will not operate:
Check the auger bolts and replace if broken off with the wrench handle.
Secure the auger bolts with 6 mm nuts.
Two spare auger bolts are supplied with the snowblower.
32
WRENCH
HANDLE
A
To Next Page
Loading...
