Honda Marine BF25A User Manual

SERVICING YOUR OUTBOARD MOTOR
Engine Oil Change
An engine oil evacuatiordfilling
device may be used to remove/add
the engine oil.
Drain the used oil while the engine is
warm. Warm oil drains quickly and
completely.
1. Unlatch and remove the engine
cover (p.
58 ).
SEALING WASHER
/-
DRAIN BOLT
2. Remove the oil filler cap, and
remove the engine oil drain bolt.
3. Allow the used oil to drain
completely, then reinstall the
engine oil drain bolt, and tighten it
securely.
piiq
Improper disposal of engine oil
can be harmful to the environment.
If you change your own oil, please
dispose
of the used oil properly.
Put it in a sealed container, and
take it
to a recycling center. Do
not discard it in a trash bin or
dump it on the ground.
4. With the outboard motor in a
vertical position, fill to the upper
limit mark on the dipstick (p.
58 )
with the recommended oil.
Engine oil refill capacity:
Without oil filter change:
1.7 US qt (1.6 Q , 1.4 Imp qt)
With oil filter change:
2.0 US qt (1.9 Q , 1.7 imp qt)
5. Install the oil filler cap and tighten
it securely.
6. Install and lock the engine cover.
59

Honda Marine BF25A Specifications

General

Max Output	25 HP
Full Throttle RPM Range	5000 - 6000 RPM
Cooling System	Water Cooled
Fuel Delivery	Carburetor
Starting System	Electric / Manual
Exhaust	Through Propeller
Lubrication	Wet Sump
Oil Capacity	1.1 L
Fuel Tank Capacity	12 L
Gear Ratio	2.08:1
Power Tilt	Optional
Engine Type	4-stroke
Recommended Fuel	Unleaded Gasoline
Propeller	3-blade (optional)
Shaft Length	20 in
Alternator	12V - 6A
Recommended Engine Oil	10W-30