Need help?Do you have a question about the Honda Outboard Motor BF130A and is the answer not in the manual?
General| Full Throttle RPM Range | 5000-6000 RPM |
|---|---|
| Starting System | Electric |
| Cooling System | Water Cooled |
| Gear Ratio | 2.33:1 |
| Alternator Output | 40 Amp |
| Trim Method | Power Trim & Tilt |
| Engine Configuration | Inline 4 Cylinder |
| Ignition System | MicroComputer Programmed |
| Lubrication | Wet Sump |
| Trim Range | -4° to +16° |
| Engine Type | 4-stroke |
| Max Output | 130 hp |
| Fuel System | Programmed Fuel Injection |
| Bore x Stroke | 87 x 99 mm |
| Exhaust | Through Prop Hub |
| Bore & Stroke | 87 mm x 99 mm |
| Rated Power | 130 hp |
| Propeller | Optional |
| Displacement | 2354 cc |
| Shaft Length | L: 508 mm, X: 635 mm, XX: 762 mm |
General safety guidelines and recommendations for operating outboard motors.
Identifies and explains the location of important safety labels on the outboard motor.
Essential safety, knowledge, and pre-operation checks for readiness.
Crucial safety measures to follow during the operation of the outboard motor.
Step-by-step instructions for the initial break-in period of the outboard motor.
Procedure for priming the fuel system and starting the outboard motor.
Procedures for both normal and emergency engine shutdown.
How to operate the gearshift and throttle controls for speed and direction.
Key safety precautions to observe during maintenance procedures.
A detailed schedule of recommended maintenance tasks and intervals.
Troubleshooting for electric starter and battery charging problems.
Solutions for issues related to the engine not starting or stalling.
Troubleshooting steps for engine overheating and low oil pressure indicators.
To Next Page