Helmet holder
The helmet holder is on the left side below
the seat.
A helmet set wire is in the tool kit. (P.29)
#
Unlocking
Open the lock cover, insert the ignition key
and turn it clockwise.
#
Locking
a
Hang both ends of the helmet set wire that
has been passed through the helmet D-ring
on the holder pin and push it in to lock.
b
Remove the key and close the lock cover.
u Use the helmet holder only when parked.
3WARNING
Riding with a helmet attached to the
holder can interfere with the rear wheel
or suspension and could cause a crash
in which you can be seriously hurt or
killed.
Use the helmet holder only while
parked. Do not ride with a helmet
secured by the holder.
Operation Guide
30
Storage Equipment (Continued)
Ignition key
Holder pin
Helmet D-ringHelmet set wire
Lock cover
To Next Page
Loading...
