Lights
6. Put the socket back into the light
assembly and turn it clockwise to
lock it in place.
7. Test the light to make sure the
new bulb is working.
8. Put the light assembly back into
the tailgate. Install the screw and
tighten it securely. Reinstall the
lens piece.
Replacing a Rear License Plate
Bulb
1. Remove the license light assembly
by carefully prying on the left
edge of the lens with a flat-tip
screwdriver and pulling the
assembly out.
2. Remove the lens from the bulb
holder by pulling the lens while
squeezing the tabs on both sides
of the holder.
3. Pull the bulb straight out of its
socket. Push the new bulb in until
it bottoms in the socket.
CONTINUED
Maintenance
To Next Page
Loading...
Need help?
General
