Press and release the Talk button.
After the beep, say ‘‘Yes.’’
HFL responds ‘‘Security is on.
Each time the vehicle is turned on,
the passcode will be required to
use the system. If you forget this
passcode, you must either go to
the dealer to have it reset, or clear
the entire system using the
System Clear command.’’
Press and release the Talk button.
After the beep, HFL prompts ‘‘The
system is locked. What is the four-
digit passcode?’’
Press and release the Talk button.
After the beep, say your four-digit
passcode.Forexample,say‘‘1,2,3,
4.’’
Ifthepasscodeiscorrect,HFL
responds ‘‘System is unlocked.’’
Press and release the Talk button.
After the beep, say ‘‘System setup.’’
HFL responds ‘‘System setup
options are security, change
passcode, call notification, auto
transfer, and clear. Press the Talk
button and say a command.’’
Press and release the Talk button.
After the beep, say ‘‘Change
passcode.’’
HFL responds ‘‘What is the four
digit number you would like to set
as your security passcode? Press
the Talk button and say the
number.’’
Ifthepasscodeisnotcorrect,please
try again according to the HFL’s
guidance.
Once a passcode is set, HFL will
prompt you for your passcode each
time the ignition switch is turned to
the ON (II) position and you press
the Talk button. You will only be
askedforthepasscodeonceper
ignition cycle.
You can also select a ‘‘System Clear’’
command to reset HFL (see page
).
Press and release the Talk button.
After the beep, say your four digit
passcode,forexample,say‘‘1,2,3,
4.’’
1.
2.
3.
1.
2.
3.
5.
358
To enter your passcode, do this; To change your security passcode, do
this:
Bluetooth
HandsFreeLink
338
０９／０４／１０ １６：４４：２７ ３１ＳＨＪ６５０ ０３４３
To Next Page
Loading...
Need help?
General
