▲▼
▲▼
CONTINUED
Adjust Outside Temp. Display
If you sometimes find that the
temperature reading is a few
degrees above or below the actual
temperature, you can adjust it by
following these instructions:
You can choose this item to
customize from ‘‘METER SETUP’’
by pressing the INFO ( / ) button
repeatedly.
Adjust the outside temperature value
by pressing the INFO ( / ) button
repeatedly. Press the SEL/RESET
button to set the desired value.
When your selection is successfully
completed, the display changes as
shown above, and then goes back to
the customize item screen.
If the ‘‘SETTING INCOMPLETE’’
message appears, go back to
‘‘ADJUST OUTSIDE TEMP.
DISPLAY’’ and repeat the procedure
again.
Multi-Information Display
Instruments and Controls
105
U.S.
Canada
U.S.
Canada
10/01/26 18:41:30 31SZA620_110
To Next Page
Loading...
