▲▼
▲▼
When your selection is successfully
completed, the display changes as
shown above, and then goes back to
the customize item screen.
If the ‘‘SETTING INCOMPLETE’’
message appears, go back to ‘‘AUTO
DOOR UNLOCK’’ and repeat the
procedure again.
If you choose ‘‘SHIFT TO P’’ or ‘‘IGN
OFF’’, you will see the above display.
Press the INFO ( / ) button to
switch the door lock mode setting
between the driver’s door and all
doors. Then, press the SEL/RESET
button to enter your selection.
Press the SEL/RESET button to see
the selections.
Select the desired setting by
pressing the INFO ( / ) button,
then enter your selection by pressing
the SEL/RESET button.
Multi-Information Display
118
10/01/26 18:43:29 31SZA620_123
To Next Page
