Honda REBEL 250 User Manual (English)

To Next Page

A Few Words About Safety

Service information

The service and repair information contained in this manual is intended for use

qualified,

professional technicians.

Attempting

service or

repairs

without the

proper

training, tools,

and equipment

could cause injury to you or others. It could also damage the vehicle or create an unsafe condition

This manual

describes

the proper methods and

procedures for

performing service, maintenance, and

repairs. Some procedures require the use of specially designed tools and dedicated equipment. Any

person who intends to use a replacement part, service procedure or a tool that is not recommended by

Honda, must

determine

the risks to

their personal

safety

and the safe operation

of the

vehicle.

you need to

replace

a part, use

genuine Honda parts with the correct part number

or an

equivalent

part.

We strongly recommended that you do not use replacement parts of inferior

quality.

For Your Customer's Safety

Proper service and

maintenance

are

essential to the customer's safety and

the

reliability of the vehicle. Any error or

oversight while servicing

vehicle can

result in faulty

operation,

damage to

the

vehicle, or injury to others.

For Your Safety

Because

this manual is intended for the

professional service technician, we do not

provide warnings about many basic shop

safety practices

(e.

Hot parts

wear

gloves). If you have not received shop

safety training or do not feel confident

about your

knowledge of safe

servicing

practice, we recommended that you do

not attempt to perform the procedures

described in this manual.

Some of the most important general

service

safety

precautions

are

given

below. However, we cannot warn you of

every conceivable hazard

that can

arise in

performing service and repair procedures

Only you can decide whether or not you

should perform

given

task.

Important Safety Precautions

Make sure you have a dear

understanding of all

basic shop safety practices and

that

you are

wearing

appropriate clothing and using safety equipment. When performing any service task, be especially

careful

of the

following:

• Read all of the instructions before

you

begin, and make sure

you

have the tools, the replacement

repair

parts,

and the skills

required

perform

the tasks

safely and completely.

• Protect your

eyes by

using proper safety glasses, goggles or face shields

any

time

you

hammer

drill, grind, pry or work around pressurized air or liquids, and springs or other stored-energy

components If there

is any doubt, put

eye

protection

AWARNING

Improper sen/ice or repairs can create an unsafe

condition that can cause your customer or others to be

seriously hurt or killed.

Follow the procedures and precautions

in this

manual

and ether service materials carefully.

AWARNING

Failure to

properly follow Instructions and precautions

can cause you to be seriously hurt or killed.

Follow the procedures

and

precautions in

this

manual carefully.

Need help?

Do you have a question about the Honda REBEL 250 and is the answer not in the manual?

Honda REBEL 250 Specifications

General

Engine Type	234cc air-cooled parallel-twin four-stroke
Compression Ratio	9.2:1
Induction	Two 26mm CV carburetors
Ignition	CDI
Transmission	Five-speed
Final Drive	Chain
Front Suspension	33mm fork; 4.6 inches travel
Rear Suspension	Dual shocks with five-position spring preload adjustability; 2.9 inches travel
Front Brake	Single disc with twin-piston caliper
Rear Brake	Drum
Front Tire	110/90-16
Rear Tire	130/90-15
Wheelbase	1, 470mm (57.9 inches)
Seat Height	690mm (27.2 inches)
Fuel Capacity	2.6 gallons, including 0.7-gallon reserve
Bore x Stroke	53 x 53mm
Displacement	234cc
Fuel System	Carburetor
Width	32.3 inches
Dry Weight	149kg (328 lbs)