Need help?Do you have a question about the Honda SL350 and is the answer not in the manual?
General| Ignition | Battery and coil |
|---|---|
| Transmission | 5-speed |
| Final Drive | Chain |
| Front Suspension | Telescopic fork |
| Front Brake | Drum |
| Rear Brake | Drum |
| Bore x Stroke | 64.0 mm x 50.6 mm |
| Horsepower | 33 hp |
| Fuel System | Two Keihin carburetors |
| Rear Suspension | Dual shocks |
| Engine Type | Air-cooled, four-stroke, parallel twin |
Locates and identifies frame and engine serial numbers for motorcycle identification.
Outlines essential checks before each ride for safe operation and performance.
Details procedures for maintaining proper lubrication levels for engine and components.
Provides step-by-step instructions for draining and refilling engine oil and replacing the filter.
Explains fork oil change procedure, including draining, refilling, and seal inspection.
Covers drive chain lubrication, adjustment, and wear inspection for optimal performance.
Discusses tire pressure maintenance, spoke condition checks, and wheel balancing.
Details how to perform a compression test to assess engine cylinder health.
Provides instructions for adjusting valve clearance to ensure proper engine operation.
Covers inspection, cleaning, gapping, and replacement of contact breaker points.
Explains methods for setting ignition timing using static and dynamic timing procedures.
Guides on spark plug cleaning, inspection, gapping, and selection based on heat range.
Details carburetor adjustments for float level, idle speed, and mixture for optimal performance.
Provides essential precautions and advice for engine work, emphasizing care and proper procedures.
Outlines procedures for safely removing and reinstalling the engine into the motorcycle frame.
Details the process for disassembling and servicing the upper engine components.
Explains the removal, inspection, and installation of the centrifugal oil filter for engine protection.
Describes the basic function and operational theory of the motorcycle's carburetor system.
Provides step-by-step instructions for disassembling, cleaning, inspecting, and reassembling carburetors.
Details the cleaning and inspection procedures for the fuel petcock and associated lines.
Explains the components and operation of the ignition system for reliable spark generation.
Details the alternator, rectifier, and voltage regulator functions for battery charging.
Guides on troubleshooting ignition circuit issues using test lights, ohmmeters, and continuity testers.
Covers starter motor removal, disassembly, inspection, and assembly procedures.
Explains how to test various electrical switches like ignition, clutch, brake, and neutral switches.
Covers the removal, installation, and service of wheels, hubs, and both drum and disc brakes.
Explains disc brake maintenance, including fluid flushing, bleeding, and pad replacement.
Details the inspection and service procedures for the drum brake system, including linings and drums.
Covers the removal, disassembly, inspection, and assembly of the front fork suspension system.
Details the adjustment, inspection, and overhaul of the steering stem bearings for smooth steering.
Explains the procedure for removing, inspecting, and installing wheel bearings and related components.
Covers the removal and disassembly of the handlebar assembly, including cables and controls.
Advises on periodic inspection of the frame for cracks or fractures, emphasizing safety.
Guides on diagnosing and resolving common engine problems related to ignition, fuel, and compression.
Provides solutions for issues like clutch slips, drags, noisy operation, and transmission gear problems.
Offers guidance on diagnosing and fixing carburetor issues such as flooding, lean/rich mixtures, and idle problems.
Addresses common chassis problems including suspension, steering, and brake issues.
Helps diagnose and resolve electrical system faults, including charging, ignition, and starter issues.
Covers common battery problems like sulfation, self-discharge, and low/high charging rates.
Provides a table for converting various units of measurement, useful for technical specifications.
Lists tap drill sizes corresponding to standard screw and tap sizes for thread tapping.
Offers decimal equivalents for standard numbered drill bit sizes for precise measurements.
To Next Page
