To Next PageTo Next Page
Need help?Do you have a question about the Honda WB30XH and is the answer not in the manual?
General| Displacement | 163 cc |
|---|---|
| Pump Type | Centrifugal |
| Suction Bore | 3 inches |
| Discharge Bore | 3 inches |
| Starting System | Recoil Start |
| Engine Type | 4-Stroke, OHV |
| Port Size | 3 inches |
| Suction Lift | 26 ft (8 m) |
| Max Flow Rate | 290 gal/min (1, 100 l/min) |
| Max Head | 82 ft (25 m) |
| Total Head Lift | 30 meters |
| Fuel Tank Capacity | 0.77 US gal (2.9 l) |
| Weight | 27 kg |
| Dry Weight | 53 lbs (24 kg) |
Warning against operating the generator inside residential buildings or enclosed spaces.
Instruction to store and operate the generator away from combustible substances.
Prohibition of smoking near the generator to prevent fire hazards.
Warning to avoid spilling fuel or oil, which can be hazardous.
Safety measure to keep the generator inaccessible to children.
Procedure to verify the engine oil level before starting operation.
Procedure to verify the fuel level in the tank before operation.
Inspect the air filter element for accumulated dust and debris.
Instructions for cleaning the air filter element.
Setting the fuel valve to the 'ON' position to allow fuel flow.
Positioning the throttle lever for starting the engine.
Adjusting the choke lever to the closed position for cold starts.
Activating the engine ignition switch to the 'ON' position.
Method for pulling the starter grip to crank the engine.
Moving the choke lever to the open position after starting.
Adjusting the throttle lever to the desired operating speed.
Moving the throttle lever to the extreme right position for shutdown.
Deactivating the engine ignition switch to the 'OFF' position.
Setting the fuel valve to the 'OFF' position to stop fuel flow.
General guide for periodic checks and replacements based on operating hours.
Procedures for cleaning components and readjusting settings as needed.
Recommendation to seek service from an official Honda dealer for maintenance.
Step to remove the cap for accessing the oil filling port.
Procedure for removing old engine oil from the crankcase.
Process of adding new engine oil to the correct level.
Detaching the spark plug from the engine cylinder head.
Removing carbon or oil deposits from the spark plug tip.
Checking and adjusting the gap between spark plug electrodes.
Detaching the fuel filter's collection cup for cleaning or inspection.
Emptying the fuel tank for long-term storage.
Removing residual fuel from the carburetor.
Emptying the engine oil for storage.
Diagnosing and resolving issues when the engine fails to start.
Troubleshooting steps for when the pump fails to move water.
Inspecting the fuel strainer for blockages or debris.
Verifying secure attachment of the hose clamp.
Checking the suction or discharge hose for any physical damage.
Diagnosing issues related to excessive suction or total head height.
Guidance to contact a Honda dealer for complex issues or repairs.
