Honeywell Home 5800MINI User Manual

5800MINI
1- Zone Door/Window
Transmitter
Installation & Setup Guide
FEATURES
•
Single zone Door/Window Transmitter
• Compatible with alarm systems that support 5800 series
wireless devices
• Built-in unique serial number which must be enrolled into
the control panel
• Refer to the control panel’s installation instructions for
programming details.
5800MIMI-001-V0
LED Indicators
LED
Meaning
Blue
Lights when the magnet is within proper range of the 5800MINI (1 inch
max). LED is active for 15 minutes after battery is first installed or when the
cover is removed.
Green
Flashes when the 5800MINI transmits. LED is active for 15 minutes after
battery is first installed or when cover is removed.
Red
Upon low battery condition, flashes once about every five seconds for two
minutes after a transmission.
MOUNTING
•
Choose a mounting location where the device is stationary and the magnet is
mounted to the moving part of the door or window.
• Verify adequate signal strength by using the control panel’s Go/No Go test (see
control’s instructions) before mounting permanently.
• Avoid mounting in areas where it will be exposed to moisture or where the operating
temperature of 32 to 120ºF (0 to 50ºC) will be exceeded.
• Keep the 5800MINI and magnet away from metal or metallic surfaces such as foil
wallpaper.
• Avoid mounting the 5800MINI in areas with a large quantity of metal or electrical
wiring, such as a furnace or utility room.
1. Install the Battery
a. Open the cover.
b. Install the battery with “+
++
+” side up.
c. Replace the cover.
The blue and green LEDs will be active for 15
minutes. To reactivate, remove the cover.
2. Mount the 5800MINI & Magnet
a. Mount the 5800MINI on the frame of the
protected door or window using double-faced
tape (supplied).
b. Mount the magnet (supplied) on the protected
door or opening portion of the protected
window. Check that the blue LED lights when
the door or window is closed.
5800MIMI-002-V0
5800MIMI-009-V0
5800MIMI-008-V1
CORRECT INCORRECT
X

Honeywell Home 5800MINI Specifications

General

Battery Life	3-5 years
Battery Type	CR2032
Frequency	345 MHz
Supervisory Interval	60 minutes
Type	Wireless
Battery	3V Lithium
Compatibility	Honeywell

Summary

Installation & Setup Guide

Features

Details the key features of the 5800MINI Door/Window Transmitter, including zone, compatibility, and serial number.

LED Indicators

Explains the meaning of the Blue, Green, and Red LEDs and their operational states for status indication.

Mounting and Installation

Provides instructions for mounting the device, installing the battery, and proper placement of the transmitter and magnet.

Programming and Battery Replacement

Programming

Guides on entering programming mode and enrolling the transmitter's serial number into the control panel.

Battery Replacement

Step-by-step instructions for replacing the transmitter's battery, including safety precautions.

Specifications

Lists technical details such as dimensions, operating conditions, magnet gap, and battery type.

FCC/IC Statement

Contains compliance information regarding FCC and Industry Canada regulations.

Support and Warranty

Provides information on accessing documentation, online support, and warranty details.