Honeywell Home SiXSIREN User Manual

SiXSIREN
Wireless Siren/Strobe
Installation and Setup Guide
This wireless siren/strobe is intended for use with Honeywell Home controls that support SiX™ series devices.
SiXSIREN
OPEN
Gently twist the top of the Siren counterclockwise and the mounting bracket clockwise to separate them.
OPEN
MOUNTING
The SiXSIREN can be mounted on the wall or on the ceiling.
The rear tamper breakout [A] MUST be mounted to a stud, solid wood, or with a robust wall anchor.
After enrolling, verify adequate signal strength by conducting Go/No Go tests (see controller’s instructions) with the device
in its intended mounting location. Adjust the device location and orientation as necessary.

Honeywell Home SiXSIREN Specifications

General

Brand	Honeywell Home
Model	SiXSIREN
Category	Home Safety Product
Language	English

Summary

Installation and Setup Guide

Mounting

Mounting Location

The SIXSIREN can be mounted on the wall or ceiling, with tamper breakout to stud/wood.

Enrollment Process

Device Enrollment Steps

Insert batteries, wait for Green LED flash, controller registration, and confirmation.

Enrollment Troubleshooting

Identify non-enrollment via White LED flash or rapid Green LED after tamper activation.

Manual Enrollment & Sensor Location

Manual enrollment via controller and using sensor location feature with LED.

Programming

Defaulting the SIXSIREN

Default Procedure

Remove batteries, hold tamper, reinsert batteries, reattach cover to factory reset.

LEDs and Sounder Operation

LED and Sounder Indicators

Table detailing LED colors (R/G/W) and sounder patterns (Chirp, Warble, Pulse) for system status.

Chime Operation

Describes chime behavior based on system state (Disarmed, Armed Away/Stay, Zone Faulted).

Testing the SIXSIREN

Test Mode Activation

Activate Test Mode remotely from the controller; test annually.

Test Mode Outputs

Sounder emits Burglary warble for 3s; White LED strobes for 15s during testing.

Battery Replacement

Battery Removal and Insertion

Twist cover, remove old batteries, insert four new 1.5V AA Lithium batteries.

Battery Type Recommendations

Use 1.5V AA Lithium (non-rechargeable); avoid mixing old/new or different types.

Battery Caution

Warning against recharging, disassembling, heating, or incinerating batteries.

Specifications and Compliance

Device Specifications

Details range, battery, tamper, RF frequency, voltage, current, siren level, temp, humidity, dimensions.

Approval Listings

Lists FCC/IC, CETLus, UL, ULC certifications and RoHS compliance.

FCC/IC and RF Exposure Statements

Compliance with FCC Part 15 and IC RSS, RF exposure warning for separation distance.

Support and Warranty Information

Documentation and Support

Links to resideo.com for latest documentation and support.

Warranty Information

Link to security.honeywellhome.com/warranty for warranty details.