1. Remove override key cover with small screwdriver.
2. Insert override key and turn left to unlock safe.
3. Turn knob to right and open safe door.
STEP 2. INSTALL BATTERIES
1. Remove battery compartment (A) cover on inside
door. Insert 4 “AA” batteries (included). Ensure the
batteries are installed in the correct direction, with
regard to polarity (+ and -).
2. Replace the battery cover.
3. Do not close door before testing digital lock.
Note: This safe comes with both a factory preset Master Code of 123456B and a User
Code of 159B. Both will open the safe and both must be changed for maximum security.
The User Code is the one that you would change as often as you feel the need to. Once
the Master Code is set, you can record it in a safe place. This will be helpful if you lose
your override access key and have forgotten your User Code, the Master Code will still
open the safe if the batteries are good.
!
STEP 3. PROGRAM A NEW MASTER CODE
1. With door open, press “0” “0” on keypad then press
reset button (C) inside door.
2. Yellow light will come on then enter new Master
Code within 15 seconds.
3. Enter new code (3 to 8 digits) followed by “A” or “B”.
4. Safe will beep and yellow light will turn off.
!
STEP 4. PROGRAM A NEW USER CODE
1. With door open, press reset button (C) inside door.
2. Yellow light will come on then enter new User Code
within 15 seconds.
3. Enter new code (3 to 8 digits) followed by
“A” or “B”.
4. Safe will beep and yellow light will turn off.
!
To Next Page
Loading...
Need help?
General
