- 2 -
2. Plug the 5800WAVE back into the AC receptacle.
3. Insert the hold down screw (supplied) in the 5800WAVE
mounting hole and secure the case to the receptacle as
shown in Figure 5.
4. When the yellow LED turns off, arm the control and
verify that the red LED turns on. Then disarm the
control.
5. With the control in the TEST Mode, test the 5800WAVE
sounder by causing an alarm.
5800WAVE-001-V0
RED
LED
YELLOW
LED
GREEN
LED
SIREN
OUTLET
INDEXER
MOUNTING
HOLE
234561 78
ON
OFF
5800WAVE-004-V1
SIREN WIRE
HOLD DOWNS
BATTERY
JUMPER
(DO NOT REMOVE)
BATTERY
CONNECTOR
BATTERY
CLIPS
TERMINAL BLOCK
(NOT USED)
+
+
Figure 1. 5800WAVE Siren Module Figure 2. Battery and Siren Connection Points
DIP SWITCH POSITIONS DIP SWITCH POSITIONS
House
ID
4 5 6 7 8
House
ID
4 5 6 7 8
0 – – – – – 16 ON – – – –
1 – – – – ON 17 ON – – – ON
2 – – – ON – 18 ON – – ON –
3 – – – ON ON 19 ON – – ON ON
4 – – ON – – 20 ON – ON – –
5 – – ON – ON 21 ON – ON – ON
6 – – ON ON – 22 ON – ON ON –
7 – – ON ON ON 23 ON – ON ON ON
8 – ON – – – 24 ON ON – – –
9 – ON – – ON 25 ON ON – – ON
10 – ON – ON – 26 ON ON – ON –
11 – ON – ON ON 27 ON ON – ON ON
12 – ON ON – – 28 ON ON ON – –
13 – ON ON – ON 29 ON ON ON – ON
14 – ON ON ON – 30 ON ON ON ON –
15 – ON ON ON ON 31 ON ON ON ON ON
“–“ Indicates “OFF.”
234561 78
ON
OFF
5800WAVE-005-V0
SWITCHES 1,2,3
MUST BE SET TO OFF
HOUSE ID 16 SHOWN
5800WAVE-003-V0
TAMPER
POSITION
INDICATOR
LINES
Figure 3. DIP Switch Settings
Figure 4. Optional Tamper Magnet Installation
5800WAVE-002-V1
MOUNTING
SCREW
RECEPTACLE
COVER PLATE
IN POSITION
Figure 5. Final Installation
To Next Page
Loading...
