Honeywell 5805 - ANCHORING YOUR SAFE

6
For extra security, you may want to permanently secure your safe to the oor. Pre-drilled holes for this
purpose are located on the bottom of the safe. While it is not extremely dicult to mount the safe, it is
important that you have the proper tools and knowledge to do so. If not, then you might choose to
utilize the services of a professional.
1. Unlock the safe and Pull the drawer out until it stops. On each of the drawer glides there
is a small plastic latch. To remove the drawer you need to simultaneously push down on
the left side latch while pulling up on the right side latch putting forward pressure on the
drawer as you do. This will release the drawer from the drawer glides and allow the drawer
to be removed.
2. Select a suitable and convenient location.
3. If safe is being mounted to a wood oor, then it can be secured using at least two or more of
the bottom pre-drilled holes. Lag screws and washers should be used to secure in place.
4. If safe is being mounted to a concrete slab, then after determining placement, mark the hole
positions and set the safe aside. A mortar bit will be required to drill holes into the concrete
and masonry anchors used to secure in place.
5. Once safe is properly mounted, replace the drawer by positioning back onto the drawer
slides and closing.
It is important to note that if prior to installation you have any questions and/or concerns regarding the
proper securing of the safe to a wall or oor you should check with your local home center / hardware
retailer or independent contractor. The securing of the safe to a wall or oor is at the consumer’s
expense and discretion. LHLP, Inc. is not responsible for any costs incurred if the unit is damaged
and needs to be replaced.
ANCHORING YOUR SAFE
IMPORTANT: To avoid
tipping when the safe
drawer is pulled out, it is
recommended that the safe
be mounted before use.