Honeywell 60S - Scan Wedge Operations; Restarting the Scan Wedge; Append Carriage Return to Barcode Scan; Using the Scan Wedge on the Handheld Desktop

60s Handheld Informaon
1
RESTARTING THE SCAN WEDGE
1. Tap the barcode icon in the system tray.
2. Select Exit
3. Tap the Start buon in the lower le corner of the system tray.
4. Select Power Tools
5. Select Scan Wedge (This should pop up saying it is inializing.)
6. Tap the “OK” buon at the boom of the screen.
7. The barcode icon should now show in the system try. Tap on it.
APPEND CA RRIAGE RETU RN TO BARCODE SCAN
1. Tap the barcode icon in the system tray. If barcode icon is not there, complete steps 3
through 7 of Restarng the Scan Wedge
2. Tap on Sengs.
3. Tap on the folder labeled Sengs.
4. Double tap on SuxKeys
5. Set the Value to 13
6. Tap “OK” buon at the boom of the screen.
7. Tap “File” in the boom le of the screen.
8. Select Save
9. Tap “File” in the boom le of the screen.
10. Select Exit
11. Restart The Scan Wedge (Please see Restarng the Scan Wedge)
USING THE SCAN WEDGE ON THE HANDHELD DESK TOP
1. Tap the barcode icon in the system tray. If barcode icon is not there, complete steps 3
through 7 of Restarng the Scan Wedge
2. Scroll down unl you see Blacklist
3. If the symbol next to it is a +, tap it to expand the folder.
4. Select Desktop
5. Uncheck all boxes here.
6. Tap “File” in the boom le of the screen.
7. Select Save
8. Tap “File” in the boom le of the screen.
9. Select Exit
10. Restart The Scan Wedge (Please see Restarng the Scan Wedge)