Honeywell 60S - Application and System Customization; Install USB Driver; Install GigaTrak Handheld Application; Adding;Moving the Icon on the Start Menu

60s Handheld Informaon
3
2. Look for the installaon le (i.e. drvupdate-x86.exe) and run it. We recommend that you follow
the installaon instrucons and accept the standard default sengs during your install.
INSTALL USB DRIVER
BEFORE connecng the handheld computer to a host USB port for the rst me, you must install the
USB driver provided with the handheld computer on your PC. This will likely be downloaded from the
WEB. Complete the driver installaon as instructed during the installaon procedure. (NOTE: Some
handheld models may not require a driver to be loaded. Refer to the installaon instrucons.)
Connect the USB cable to your PC and the handheld or docking staon (if provided). Windows will
locate the hardware and complete the installaon.
INSTALL GIGATRAK HAN DHELD APPLICATION
The handheld applicaon can be found in the Handheld folder of your installaon download.
1. Connect the handheld docking staon to your computer (typically a USB connecon) and plug
in the AC power cable.
2. Put the handheld in the dock and wait for it to sync with the PC.
3. On the PC, double-click the handheld setup le for the applicaon you are installing (e.g.,
setup_honeywell_hh.exe).
ADDING/MOVING THE ICON ON THE START MENU
1. Find the TTS Icon. If the icon is not available follow the leered steps below.
a. Tap the Start buon in the lower le corner of the system tray.
b. Select File Explorer
c. Using the top le, go to My Device -> Program Files ->Tool Tracking System
d. Tap and Hold on the TTS Icon
e. Select Copy
f. Using the top le, go to My Device -> Windows -> Start Menu -> Programs
g. Tap and Hold on an open space
h. Select Paste Short Cut
2. Hold down on the icon unl it highlights and lis up.
3. Drag the icon to the new locaon.
4. Release the icon.
REPORGRAMING THE SOFT KEYS
1. Tap the Start buon in the lower le corner of the system tray.
2. Select Sengs.
3. Select Personal.
4. Select Buons.
5. Select the So key you would like to change
6. Use the drop down menu below to select what you would like to assign to that so key. Note:
You can assign a so key to start a program by selecng a program or as an alternate scan
buon by selecng <Scan2>.
7. Tap the “OK” buon at the boom of the screen.