To Next PageTo Next Page
Need help?Do you have a question about the Honeywell 8EP416 and is the answer not in the manual?
General| Zones | 16 |
|---|---|
| Hardwired Zones | 8 |
| Input Voltage | 16.5 VAC |
| Output Voltage | 12 VDC |
| Operating Temperature | 32°F to 120°F (0°C to 49°C) |
| Weight | 1.6 kg (3.5 lbs) |
Discusses planning the alarm system layout, detector placement, and cable runs.
Provides instructions on how to physically mount and install the control panel.
Illustrates how to connect LED and LCD keypads to the control panel.
Provides step-by-step instructions for mounting and wiring remote keypads.
Recommends limits for zone wiring and illustrates zone wiring configuration.
Covers the wiring and terminals for connecting an external siren/strobe.
Details connections for remote signalling equipment like communicators or speech diallers.
Lists the default factory settings for various system parameters.
Details the correct method for connecting the panel to the mains power supply.
Steps for completing system wiring, programming, and initial testing.
Guides the user through the initial power-up sequence after installation.
Overview of entering and operating the engineer programming mode.
Details how to access and exit the engineer programming mode using codes.
Steps to revert the panel to its factory default settings.
Procedures to reset user and engineer codes to their default values.
Describes how to test the bell, strobe, and sounder outputs of the system.
Details how to test various system outputs like Fire, PA, Intruder, Set, and Abort.
Step-by-step guide on how to set the alarm system using LCD and LED keypads.
Instructions for unsetting the alarm system via LCD and LED keypads.
General information about common fault conditions and troubleshooting.
Detailed technical specifications for the Accenta/Optima system.
