8
FINAL INSTALLATION
4. Partially insert the blade screws along with blade washer through blade and into the blade arm. Tighten each blade screw with a
Phillips screwdriver, starting with the one in the middle. Repeat this step for the remaining blades and blade arms (Figura 5.4).
5. Insert blade arm through slot in the side of the motor assembly. Align the holes of one blade arm with two motor screw holes
in underside of the motor assembly. Secure with two motor screws. Repeat this step for the remaining blade arms (Figure 5.5).
6. Remove two of the four fitter plate screws located on the underside of the motor assembly and loosen the other two screws.
Align the two key slots of the light kit with the loosened fitter plate screws. Rotate the light kit clockwise until the screw heads
engage the key slots. Replace previously removed fitter plate screws, then tighten all screws (Figure 5.6).
7. Remove the four switch housing cover screws preassembled to the switch housing. Set aside for later (Figure 5.7).
8. Remove the four switch housing screws preassembled to the light kit. Secure the switch housing to the light kit by re-
installing the switch housing screws. Note: The switch housing should be oriented so its notch covers the wiring from the
light kit (Figure 5.8).
9. Connect the two 4-pin connectors and two 9-pin connectors from the switch housing. Insert the connectors into the switch
housing. Then, install the switch housing cover to the switch housing using the switch housing cover screws that were
previously removed (Figure 5.9).
Figure 5.5Figure 5.4 Figure 5.6
Blade Screw
Light Kit
Key Slot
Fitter Plate
Screw
Blade Washer
Blade Arm
Blade Arm
Slot
Motor Screw
Blade
Figure 5.8Figure 5.7 Figure 5.9
Switch Housing
Cover Screw
Switch Housing
Screw
Switch Housing
Cover
Switch
Housing
Switch Housing
Cover Screw
9-pin
Connector
4-pin
Connector
To Next Page
Loading...
