11
USE & OPERATION
FILLING WATER (CONTINUOUS WATER SUPPLY CONNECTION)
Connect water pipe to the continuous water supply connector located on the lower left side
panel. Secure the connector with the pipe so that there is no leakage and turn on the water
supply.
With the help of the water auto-refill mechanism, water inside the tank will refill automatically.
Everytime the water comes below the minimum level, the water float valve will detect it and
will start the water flow inside the tank. In the same way it also stops water in-flow when
reaching the maximum level.
This is an automated process and will not require you to refill the water tank manually.
Plug the unit into the power supply and turn the unit on.
INSTALLING HOSE ADAPTER AND FLOAT VALVE
• Connect the garden hose Connector and turn on the water.
• Verify water tight connections by visually examining both
the float/hose connections.
Hose Connector
To Next Page
Loading...
Need help?
General
