To Next Page

To Previous Page

CLEANING & MAINTENANCE

DRAINING AND CLEANING THE WATER TANK

CLEANING THE FILTER AND HONEYCOMB

Water Drain

Open Screws

Plug

•

Turn the power “off” and disconnect the air cooler from the

power supply.

Move the unit to a location where it can be drained. Remove

the cap from the water drain plug and allow the tank to empty

(see parts description on page 7).

After you have drained the water tank, please connect the water

drain plug to its original position.

Now refill the water tank up to Max level, wait for 5 min. and then

drain the entire water once again. Use clean water for this proce-

dure, so that maximum dust particles and remains are completely

removed.

If your cooler has not been used for a long duration, we advise

you to clean the water tank at least 2 times before it is used

again.

Turn off the unit, and unplug the power cord from wall outlet.

Rotate the unit facing the back panel, and locate the Rear Grill

Removal Screws (refer page 7., #15). Remove both the screws

with a screw driver.

Pull the rear grill panel upwards, until it is completely removed.

Now, the carbon filter and Honeycomb Media can be seen.

Clean both the filters with a clean cloth to remove all the dust

& dirt particles.

Once the cleaning has been completed, assemble the unit as

described above.

Plug into the power supply and turn on unit.

Honeywell CL40PM User Manual

Other manuals for Honeywell CL40PM