To Next Page

To Previous Page

69-0756—2

STEP 1 Use a large enough container, such as a

laundry tub or trash container, to hold one or

both cell(s).

NOTE: Sharp corners on the cell(s) can scratch

the surface of a bathtub.

STEP 2 Dissolve about 3/4 cup of automatic dishwasher

detergent per cell in enough hot water to cover

the cell(s). If the detergent does not dissolve

readily, or forms a scum on the water, try

another brand, or use softened water.

STEP 3 After the detergent has completely dissolved,

place the cell(s) in the container and let soak for

15 to 20 minutes. Agitate them up and down a

few times, and remove.

STEP 4 Next, wash the prefilter(s) the same way. Empty

and rinse the wash container.

STEP 5 Rinse the cell(s) and prefilter(s) with a hard

spray of very hot water; rinse the tub clean,

then fill the tub with clean hot water and soak

for 5 to 15 minutes. Rinse until the water

draining from the cell(s) and prefilter(s) no

longer feels slippery.

STEP 6 Soak cell(s) and prefilter(s) in a final clear water

rinse for 10 minutes.

STEP 7 Wipe the ionizer wires and contact board on the

end of the cell using your thumb and forefinger

with a small, damp cloth.

Use the hand sprayer at a coin-operated do-it-

yourself car wash to wash the cell(s). Hold the

nozzle at least two feet away from the unit to

avoid damage (such as broken ionizer wires or

bent collector plates) from the high pressure

stream of water. Follow the same sequence of

wash and rinse as recommended for cars.

However, do not wax the cell(s). Be sure to

rinse until the water draining from the cell(s) no

longer feels slippery.

Washing the cell(s)

at a car wash

Honeywell F50F User Manual

Other manuals for Honeywell F50F