FocusPRO TM TH6110D Programmable Thermostat
Follow tile procedure below to test the heating, cooling and fan.
System test System
number status
J
To begin, press and hold the A and T
buttons until the display changes
System Test System Status
Press A to turn on system
Press Y to turn off system
Press NEXTto advance to next test
Press DONEto terminate system test
10 Heating system
30 CooEng system
40 Fan system
70 Thermostat
information
(for reference only)
0 Heat and fan turn off.
1 Heat turns on. Fan also turns on immediately if Function 1 or 3
is set to "1" (see page 8).
0 Compressor and fan turn off.
1 Compressor and fan turn on.
Fan turns off.
Fan turns on.
71 Software revision number (major revisions)
72 Software revision number (minor revisions)
73 Configuration identification code (major)
74 Configuration identification code (minor)
75 Production configuration date code (week)
76 Production configuration date code (year)
CAUTION: EQUIPMENT DAMAGE HAZARD
Compressor protection (minimum off time) is bypassed during testing. To prevent
equipment damage, avoid cycling the compressor quickly.
To Next Page
Loading...
