To Next PageTo Next PageWhat to do if the Honeywell Security Camera power supply is unstable?
If you are experiencing an unstable power supply with your Honeywell Security Camera, it is strongly recommended to use a UPS (Uninterruptible Power Supply).
General| Model | HC35WB8R2 |
|---|---|
| Focal Length | 2.8 mm |
| Optical Zoom | No |
| Protection | IP66 |
| Weather Resistance | Yes |
| Motion Detection | Yes |
| Night Vision | Yes |
| Connectivity | Wired (Ethernet) |
| IR Distance | 30m |
| Power Source | PoE (Power over Ethernet) |
Instructions for installation, operation, and general safety precautions.
Information on using specified replacement parts and warranty service.
Steps to install the Honeywell Unified Tool software.
Process for finding cameras on the network and performing initial setup.
Process for locating cameras on the network using the tool.
Instructions for the initial setup and configuration of cameras.
Procedure for upgrading firmware and accessing the camera via web browser.
Guide on how to assign static IP addresses to the cameras.
Procedure for updating the camera's firmware.
Steps to access the camera's interface through a web browser.
Detailed steps for accessing the camera's web client for live viewing.
Network conditions and steps required for successful camera login.
Configuration of general camera parameters and video stream settings.
Using the Unified Tool to scan the network and detect cameras.
Steps for initializing cameras, including setting passwords and protocols.
Detailed steps for configuring IP address, subnet mask, and gateway.
Procedure to update the camera's firmware using the Unified Tool.
Steps to access the camera's interface by entering its IP address in a browser.
Configuration of video stream settings including codecs, resolution, and frame rates.
Fine-tuning image parameters like brightness, contrast, and sharpness.
Adjusting image brightness, saturation, contrast, and sharpness levels.
Configuration of exposure settings, including meter area and auto/manual modes.
Adjusting color temperature using preset modes or manual gain sliders.
Configuration of day/night switching modes, timing, and IR LED behavior.
Setting up IP protocol, DHCP, fixed IP, DNS, and MTU.
Setup and configuration of motion detection parameters and sensitivity.
Setting up smart motion detection to identify specific objects in motion.
Configuring tamper detection to alert when the camera is interfered with.
Setting up intrusion detection to identify unauthorized entry into defined areas.
Solutions for common performance problems like unstable power or abnormal display.
