Honeywell Home Pro Series - UWP Mounting Procedure; Power Options; Connecting Power Wires; Setting Slider Tabs

Before starting, turn the power off at the breaker box or switch. Open package to find the5.
UWP. See Figure 5.
Position the UWP on wall. Level and mark hole positions. See Figure 6.6.
Drill holes at marked positions, and then lightly tap supplied wall anchors into the wall
using a hammer. ‒ Drill 7/32” holes for drywall.
Pull the door open and insert the wires through wiring hole of the UWP. See Figure 7.7.
8Place the UWP over the wall anchors.Insert and tighten mounting screws supplied with the8.
UWP. Do not overtighten. Tighten until the UWP no longer moves. Close the door. See
Figure8.
Power options
Setting Slider Tabs