Need help?Do you have a question about the Honeywell HUS-NVR-1032/6032-E and is the answer not in the manual?
General| Model | HUS-NVR-1032/6032-E |
|---|---|
| Type | Network Video Recorder |
| Channel Support | 32 channels |
| Video Compression | H.264 |
| Operating System | Embedded Linux |
| Video Output | HDMI, VGA |
| Hard Drive Support | SATA |
| Audio Input/Output | 1/1 |
| Network Interface | 1 RJ-45 10/100/1000 Mbps |
| USB Interface | 2 x USB 2.0 |
| Power Supply | 100 to 240 VAC, 50/60 Hz |
| Operating Temperature | -10°C to 55°C |
Conforming installation and operation to local electrical safety codes.
Avoiding pressure, vibration, and water during transit, storage, and installation.
Proper installation and operation in suitable environments, avoiding extreme heat, humidity, dust, or vibration.
Information on built-in battery life, replacement, and battery type.
Referring to the rating plate for information and following user guide instructions.
A brief introduction to the user guide's structure and content.
Explains the meaning of italic and bold text, and warning symbols.
Guidance on using the manual, noting that pictures are for reference and content may change.
Details NVR capabilities like real-time surveillance, record/playback, alarm, and PTZ control.
Details NVR specifications including storage, backup, network, and ports.
Details the buttons and indicators on the NVR's front panel.
Describes the ports and connectors on the NVR's rear panel.
Step-by-step guide for installing Hard Disk Drives (HDDs) into the NVR.
Details connections for video and audio signals, including input and output ports.
Explains alarm input and output connections, specifications, and examples.
Describes how to connect the NVR to a network using RJ45 ports and recommended network devices.
Details USB and e-SATA port connections for connectivity and storage.
Instructions on how to operate the NVR using a connected mouse.
Procedures for powering on the NVR, language selection, and default accounts.
Guide to using the setup wizard for initial NVR configuration.
Configuring storage (disk formatting) and adding devices (cameras) via the wizard.
How to switch users, change passwords, and log off the system.
Procedures for restarting and shutting down the NVR system.
Recommendations for replacing the system's button cell battery.
Viewing live video, navigating menus, and basic interface operations.
Manipulating video windows, including layout, playback, zoom, and stream switching.
Controlling PTZ cameras, saving presets, and configuring patrol sequences.
Playing back recorded videos, searching for events, and using playback controls.
Methods for backing up and exporting video clips to external devices.
Viewing and managing system operation, alarm, and input logs.
Monitoring system performance, network status, and hard disk health.
Configuring recording modes, scenarios, trigger profiles, and alarm schedules.
Configuring general settings, system information, display, user, network, and alarms.
Managing RAID arrays, virtual disks, and storage configurations.
Hardware/software needs and configuring Internet Explorer for NVR access.
Configuring Internet and Intranet zone security settings for browser access.
Logging into the NVR and viewing live video streams via the IE Client.
Recording live video locally and playing back saved clips through the IE Client.
Managing NVRs and IP cameras remotely using the IE Client.
To Next Page