BASE ASSEMBLY INSTRUCTIONS
NOTE: THESE
INSTRUCTIONS ARE FOR
MODEL HV-141 (NO BASE
WEIGHT INCLUDED/FIG. 1)
AND HV-181 (WITH BASE
WEIGHT/FIG. 1A).
IF YOU HAVE MODEL HV-
141 (Fig.1), PLEASE FOLLOW
THESE INSTRUCTIONS BUT
DISREGARD REFERENCES
TO BASE WEIGHT.
• Remove the base extension
pole, base with attached
base weight (Fig.1A), #10
metric socket wrench and
(5) bolts and (5) nuts from
the box.
• Place the base on the
floor with the weight on
the bottom, line up the base
extension pole holes with
those in the base and firmly
insert the pole into the base.
NOTE: It may be
easier for you to
insert and tighten
each bolt individually
instead of all 5 at
once. Use the method
you are most
comfortable with.
• When you are finished
attaching all (5) bolts, flip
the base back over so
that the base extension
pole is now facing up.
• Separate the nut and metal
washer from each bolt.
• Using your fingers, press
one bolt through the base
extension pole plate, and
into the base until it is
almost flush with the plate.
• Once the bolt is inserted,
carefully turn over the base
and pole so the base weight
is facing upright.
• Take a metal washer and
drop it into the hole so it fits
around the bolt.
• Then take a nut and fit it
into the #10 metric socket
wrench (included). You may
then, using the tool, thread
and secure the nut around
the bolt. Do not completely
tighten
• Repeat for all 5 bolts,
then tighten.
Fig. 1
BASE
EXTENSION
POLE
BASE
BOLTS
NUTS
Fig. 1A
BASE
EXTENSION
POLE
BASE
BOLTS
BASE
WEIGHT
NUTS
WASHERS
WASHERS
HV-181
HV-141
To Next Page
Loading...
Need help?
General
