EasyManuals Logo

Honeywell HY-022 Series User Manual

Honeywell HY-022 Series
11 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #2 background imageLoading...
Page #2 background image
NOTE: Remove all contents from the box being careful not to discard the manual.
Remote Control Battery Installation/Replacement
The remote control is located in the upper portion of the front
housing. Press on the remote control until you hear a “click”
sound to remove it from the recessed storage area in the fan
(Fig 1).
Locate the tab on the side of the remote and gently squeeze the
tab and pull away from the remote (Fig 2).
Remove the clear plastic protective sticker from the Lithium
CR2025 battery and place the battery back in the holder and
push the holder back into the remote. Make sure the (
+
+
) side
is facing upward.
To store the remote control, insert it back into the opening located
on the front of the fan. You will hear a “click”, indicating the
remote is properly stored.
The fan is now ready to be used.
Note: When replacing the battery, please follow the above
instructions.
HY-022 SERIES ASSEMBLY INSTRUCTIONS
Fig. 1
NOTE: Remove all contents from the box being careful not to discard the manual and hardware needed for
assembly.
A. Fan Assembly
Align the rear and front base assembly and firmly snap together by
pushing the 4 round extrusions into the adjacent circles of the
connecting pieces (Fig 3).
Use a phillips head screw driver ( ) to secure the rear and front
base assemblies together using the two (2) smaller 3mm screws
included with the fan (Fig. 4).
Carefully turn the fan housing upside down.
Place the base onto the fan housing making sure the three screw
holes located on the bottom of the fan line up with the holes on the
base (Fig 5).
Locate the three (3) 5mm screws included with the fan and insert
them into the holes on the bottom of the base and tighten with a
phillips head screw driver ( ) (Fig. 6).
Turn the fan right side up.
B. Remote Control Battery Installation/Replacement
The remote control is located in the upper portion of the front
housing. Press on the remote control until you hear a “click”
sound to remove it from the recessed storage area in the fan
(Fig 7).
Locate the tab on the side
of the remote and gently
squeeze the tab and pull
away from the remote
(Fig 8).
Remove the clear plastic
protective sticker from
the Lithium CR2025
battery and place the
battery back in the holder
and push the holder back
into the remote. Make
sure the (
+
+
) side is facing
upward.
T
o store the remote control,
insert it back into the
opening located on the front
of the fan. You will hear a
“click”, indicating the
remote is properly stored.
The fan is no
w read
y to be used.
Note: When replacing the ba
tter
y
,
please follo
w the above instructions.
Fig. 6
Fig. 4
Fig. 3
HY-026 SERIES/HY-030 SERIES ASSEMBLY INSTRUCTIONS
Fig. 8
Fig. 2
Fig. 7
Fig. 5
HY-022-026-030_OM.qxd 10/13/06 2:07 PM Page 2

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Honeywell HY-022 Series and is the answer not in the manual?

Honeywell HY-022 Series Specifications

General IconGeneral
BrandHoneywell
ModelHY-022 Series
CategoryFan
LanguageEnglish

Related product manuals