- 4 -
FAN OPERATION
INSTALL FEBREZE
®
SET&REFRESH
®
SCENT CARTRIDGE
If you would like to use the scent distribution feature on your fan, you need to install and activate
a Febreze
®
Set&Refresh
®
scent cartridge.
Your Honeywell with Febreze Freshness™ Cool & Refresh Fan package contains one Febreze
®
Set&Refresh
®
Advanced Odor Eliminator scent cartridge at the time of purchase.
Fragrance is intended for use with Kaz fan models HY-200, HY-201 and HY-204 Series.
Make sure your fan is
turned OFF.
1 - Turn Fan Off
Remove the Set&Refresh
®
scent cartridge from the
enclosed packaging. Do not
peel or cut the cartridge
Open the door to the Scent
Cartridge Compartment
located in the center of the
fan control panel.
Hold the Set&Refresh
®
scent cartridge so that the
curved side is facing
upward.
Line the cartridge up with
the slot inside the Scent
Cartridge Compartment.
Slide the scent cartridge into
the slot until it is firmly in
place.
Close the door to the Scent
Cartridge Compartment.
2 - Remove Cartridge 3 - Open Cartridge Door
4 - Position Cartridge 5 - Insert Cartridge 6 - Close Cartridge Door
To Next Page
Loading...
Need help?
General