Honeywell HY-220 Series - Install Febreze Scent Cartridge

- 5 -
FAN OPERATION
INSTALL FEBREZE
®
SET&REFRESH
®
SCENT CARTRIDGE
If you would like to use the scent distribution feature on your fan, you need to install and activate
a Febreze
®
Set&Refresh
®
scent cartridge.
Your Honeywell with Febreze Freshness™ Cool & Refresh Fan package contains one Febreze
®
Set&Refresh
®
scent cartridge at the time of purchase.
Fragrance is intended for use with Honeywell fan models HY-200 Series and HY-220 Series.
Make sure your fan is
turned OFF.
Remove the Set&Refresh
®
scent cartridge from the
enclosed packaging. Do not
peel or cut the cartridge
Open the door to the Scent
Cartridge Compartment
located in the center of the
fan control panel.
Hold the Set&Refresh
®
scent cartridge so that the
curved side is facing
upward.
Line the cartridge up with
the slot inside the Scent
Cartridge Compartment.
Slide the scent cartridge into
the slot until it is firmly in
place.
Close the door to the Scent
Cartridge Compartment.
2 - Remove Cartridge 3 - Open Cartridge Door
4 - Position Cartridge 5 - Insert Cartridge 6 - Close Cartridge Door
1 - Turn Fan Off