EasyManua.ls Logo

Honeywell HYF500 - FUSED SAFETY PLUG - FOR US MODELS ONLY

Honeywell HYF500
12 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
tripping hazard.
19. DO NOT use an extension cord or power strip with this fan.
20. SAVE THESE INSTRUCTIONS
WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT USE THIS FAN WITH ANY SOLID-
STATE SPEED CONTROL DEVICE, OTHER THAN THE ONE SUPPLIED.
WARNING: Chemical Burn Hazard.
Keep batteries away from children. This product contains a lithium button/coin cell battery. If a new or used lithium
button/coin cell battery is swallowed or enters the body, it can cause severe internal burns and can lead to death in
as little as 2 hours. ALWAYS completely secure the battery compartment. If the battery compartment does not close
securely, stop using the product, remove the batteries, and keep it away from children. If you think batteries might
have been swallowed or placed inside any part of the body, seek immediate medical attention. The cells shall be
disposed of properly, including keeping them away from children; and even used cells may cause injury.
FUSED SAFETY PLUG – FOR US MODELS ONLY
This fan features a fused safety plug which is designed to cut off electric current to the fan if an electrical fault occurs.
Please see below for more information on how to properly use your fan and replace the safety plug fuse, if needed.
USER SERVICING INSTRUCTIONS
If your fan loses power and you suspect that the fuse on your fan has blown, grasp plug and remove from the
receptacle or other outlet device. DO NOT unplug by pulling on cord. · Slide fuse cover, located on the top of the
plug, towards the prongs of the plug. (Fig. 1)
Carefully remove the blown fuse and snap a new fuse into place. To Reduce the Risk of Fire, replace fuse only
with 2.5 Amp, 125 volt fuse. Fully close the fuse door by sliding back into place. (Fig. 2) Discard the blown fuse.
The plug should now be ready for normal use.
To Reduce the Risk of Fire, DO NOT replace attached plug. Discard product if the attached plug is damaged.
If you need further information on how or when to replace the fuse in the safety plug, please contact Helen of
Troy Consumer Relations Department by visiting our Fig. 2 website at www.HoneywellPluggedIn.com/fans or
calling 1-800-477-0457.

Related product manuals