HZ322 TrueZONE
7 69-2199—05
CONFIGURATION
To enter Configuration:
HOMEWIRELESS
MODE
BACK NEXT
CONFIG
CHECK OUT
ADJUST SETTING
1
Press the Mode button (the Config LED will
light up).
HOME
MODE
BACK NEXT
CONFIG
CHECK OUT
ADJUST SETTING
WIRELESS
2
Use the Back and Next buttons to navi-
gate through the configuration settings.
Scroll through the selection choices by
using the "Adjust Setting" Left and Right
arrow buttons. Pressing Next enters the
selected option for that menu item and
advances to the next menu.
SYSTEM TYPE
[CONV] HEATPUMP
COOL STAGES
0 [1] 2
CONVENTIONAL
HEATPUMP
HEAT STAGES
0 [1] 2
RF ENABLED
[YES] NO
NO
ASKS THIS FOR EVERY WIRED ZONE.
OPTIONS: HTPUMP-O FOR HEAT PUMP
THERMOSTATS USING O FOR CHANGEOVER,
HTPUMP-B FOR HEAT PUMP THERMOSTATS
USING B FOR CHANGEOVER, AND
CONVENTIONAL FOR CONVENTIONAL,
NON-HEAT PUMP THERMOSTATS
OPTIONS: TSTAT,
TIMER, % ZONES, OFF
ADVANCED CONFIG
[NO] YES
SAVE CHANGES
[NO] YES
COMPRESSOR STAGES
[1] 2
1
2
3
1
AUX HT ENABLED
[YES] NO
SET TO “YES” IF WIRELESS (RADIO FREQUENCY) THERMOSTATS AND THM4000R ADAPTER ARE USED.
2
YES
OPTIONS: 1, 2, 3
ZONES INSTALLED
[3]
OPTIONS: 1, 2, 3
SKS THIS FOR EVERY ZONE.
ZONES INSTALLED
[3]
RF
“YES” ALLOWS YOU TO VIEW/CHANGE THE ADVANCED
CONFIGURATION OPTIONS SHOWN ON PAGE 8.
3
4
SHOWN IF COMPRESSR STAGES OR HEAT STAGES IS SET TO 2, OR AUX HT ENABLED IS SET TO “YES”
4
RF MEANS "WIRELESS THERMOSTAT"
STAGE 2 CONTROL
[OFF]
PANEL WILL NOT ASK IF YOU HAVE AUX HEAT WHEN 2 COMPRESSOR STAGES ARE SELECTED. THE HZ432 IS REQUIRED FOR A 3H/2C HEAT-PUMP
2
1
ZONE 1 TSTAT TYPE
[RF] WIRED
ZONE 1 TSTAT TYPE
[HTPUMP-O]
WIRED
The flow chart below illustrates basic zone panel configuration. For additional configuration, see
Advanced Configuration on page 8. The label on the inside cover of the HZ322 Zone Panel also con-
tains configuration information.
3
Fig. 13
Fig. 14
To Next Page
Loading...
Need help?
General
