Honeywell LKPES8M-EN User Manual

Place one battery in each one of the
3 battery holders (read carefully the
battery replacement instructions on
page 1 before)
BATTERY REMOVAL AND HANDLING SAFETY
WARNING Risk of fire, explosion and burns, do not
recharge, disassemble, heat above 100° C, or
incinerate the battery. While the battery can normally
be safely removed by hand, care should be used to
ensure that the battery terminals are not shorted, nor
the battery damaged, during the removal process.
Dispose of depleted batteries by complying with
applicable national and local regulations. In the event
of the battery being damaged, use personal
protective equipment to remove it immediately, and
dispose of it in a safe manner (refer to the battery
manufacturer’s specifications for such situations).
For Switzerland, Annex 2.15 of SR 814.81 applies to
the battery included with this product.
3 x
Battery R e p l a c e m e n t
(CR123A)
Tag reader: identification area
Siren output
SOS keys
Audio output
System fault LED
(LED2)
System armed LED
(LED1)
Tamper alarm LED
(LED3)
Intruder alarm LED
(LED4)
Total set arming key
Partial set arming key
Product d e sc r i p t i on
© 2010 Honeywell International, Inc.
- 1 -
Mounting holes
M oun t i ng
T A G
2
4
3


Honeywell LKPES8M-EN Specifications

General

Type	Keypad
Connectivity	Wired
Material	Plastic
Color	White
Operating Temperature	-10°C to +55°C
Weight	150g
Display	LCD
Current Consumption	50mA

Summary

Product Description

Product Description Details

Diagram illustrating the keypad, tag reader, LEDs, and arming keys with their functions.

Battery Replacement and Handling

Battery Replacement Instructions

Procedure for replacing three CR123A 3V Lithium batteries, including safety warnings.

Mounting the Keypad

Mounting Procedure

Steps for mounting the keypad bracket on a wall and attaching the keypad.

Installation and Configuration

Introduction to LKPES8M-EN

Overview of the wireless audio keypad's function for controlling alarm panels.

Keypad Mounting Steps

Instructions on how to properly fix the keypad bracket and attach the keypad.

Registering the Keypad

Procedure for associating the keypad with the alarm panel using a programming tool.

Power and Maintenance

Information on battery failure signals and replacement procedures for the keypad.

Installer Programming Mode

Steps to enter installer mode for setting arming, user codes, and TAG association.

Technical Specifications

Keypad Specifications

Detailed technical data including dimensions, weight, RF range, battery, and operating conditions.

Electrical and Environmental Data

Information on supply voltage, siren output, typical consumption, and storage temperature.